Re: engine stalling at idle
 

They could be 5 volt pulses. The sensor itself puts out the volt
pulse. They only happen when it is spinning so I think a bench test
might be in order?

Basically I would put the meter on pin 1 and 2 and hand spin it to see
if it pulses. Or 1 and 3 or 2 and 3. It is something like some of the
distributor units, they show a pulse on a meter when hand moved.

Mike

updawaz00@hotmail.com wrote:
>
> Mike, It is a YJ, but it may be the same issue you are talking about. I
> purchased a service shop manual ... should get here by wednesday. It
> seems to be a gray issue on how to properly troubleshoot a sensor.
> Somewhere I heard to measure 5 volts... but where and do I have to
> pierce the insulation while the connector is connected is not
> disclosed. Hope the shop manual is worth the $100!

Re: engine stalling at idle
 

They could be 5 volt pulses. The sensor itself puts out the volt
pulse. They only happen when it is spinning so I think a bench test
might be in order?

Basically I would put the meter on pin 1 and 2 and hand spin it to see
if it pulses. Or 1 and 3 or 2 and 3. It is something like some of the
distributor units, they show a pulse on a meter when hand moved.

Mike

updawaz00@hotmail.com wrote:
>
> Mike, It is a YJ, but it may be the same issue you are talking about. I
> purchased a service shop manual ... should get here by wednesday. It
> seems to be a gray issue on how to properly troubleshoot a sensor.
> Somewhere I heard to measure 5 volts... but where and do I have to
> pierce the insulation while the connector is connected is not
> disclosed. Hope the shop manual is worth the $100!